Jump to: Introduction Specifications Options

The Basic Smartcontrol (SCB) is a proportional forward and reverse electronic motor control. This microcontroller based control also features two pulse width modulation (PWM) rates, current limiting and a diagnostic LED. The Basic Smartcontrol is factory preset for a limit current of 6.6 amps. SCB is designed to work for an unlimited time at maximum current without overheating.

The SCB is compatible with the 2.4GHz Spektrum RC System. 

Current Limiting

Smartcontrol features automatic current limiting which protects your motor in case of stalled motor and also protects the control in case of a short in the wiring. Once the current reaches the limit current (shown above) the control will automatically shut down. The user must move the stick on the transmitter to the center (off) position to restart the control. The current limiting has a start-up delay period of 1/10 of a second. During the first 1/10 of a second after moving the stick from the off position the current limiting will not activate. This allows for high current surges when the motor is starting.

The Diagnostic Light Emitting Diode (LED)

The LED provides the user with a visual indication of the state of the Smartcontrol. This is useful when adjusting the unit and also for troubleshooting problems in your R/C system. It is capable of displaying 3 different colors.

SCB Specifications - Power Section

• Recommended battery voltage range: 6 to 12 volts.
• Absolute maximum voltage: 15 volts.
• Minimum working voltage: 3.5 volts.
• MOSFET output, 1 volt drop at 5 amps (on resistance .215 ohms).
• Current Drain with control section turned off: 12 microamps.
• Limit Current: 6.6 amps

SCB Specifications - Control Section

• Absolute maximum voltage: 10 volts
• Minimum working voltage: 3.3 volts
• Current Drain: 50 milliamps

SCB Specifications - General

• Two user selectable PWM rates:
  • 100 Hz
  • 400 Hz
• Physical dimensions:
  • 2.5" long x 1.3" wide x 1.75" high (to top of bracket)
  • 64 mm x 33 mm x 45 mm
• 1 year limited warranty
• Compatability guarantee: If this Smartcontrol is not compatible with your radio you can return it within 30 days for full refund ( less shipping ).

Optional Plastic Case

• 3.3" long x 2.2" wide x 1.4" high
• 84 mm x 56 mm x 36 mm

Optional Battery Connector

Factory installed battery connector for standard NI-CAD packs.